Franklin-fueling-systems ATG Moormann Interface Manuel d'utilisateur

ATG Moormann InterfaceInstallation Guide Franklin Fueling Systems • 3760 Marsh Rd. • Madison, WI 53718 USATel: +1 608 838 8786 • 800 225 9787 • Fax:

615. If the roller brackets are threaded properly, you will nish with the last roller on the bottom of the roller bracket attached to the eccentric

8181344711719109Gauge Housing Base Support(customer supplied)1" Nipple (galv.)(customer supplied)1" Union (galv.)(customer supplied)1"

©2006 FFS 000-2033 Rev. C

Copyright ©2006 by Franklin Fueling Systems (FFS). No part of this publication may be reproduced in any form without the prior written consent of FFS

iiiImportant Safety MessagesFFS equipment is designed to be installed in association with volatile hydrocarbon liquids such as gasoline and diesel fue

The hot, neutral and ground wires for FFS controllers must be dedicated wires to the service panel and to a dedicated circuit breaker — they should no

1IntroductionFFS’s Moormann ATG interface gives an electronic means to read a Moormann mechanical gauge. The Moormann 7S tape gauge uses a 7 to 1 rati

211. Install the large pulley end of one of the pulley racks (Figure A, Item 7) to the eccentric cap using a cotter pin (Figure A, Item 17). The 7 se

23. Remove the vice grips and electrical tape, and slowly allow the counterweight assembly to drop down in the gauge tube. Once the weight assembly i

35. Install the UV guard (Figure A, Item 23) over the probe cable and route the probe cable to the junction box. The spiral UV guard should completel

5Moormann ATG Interface RetrotsThe steps below explain how to install the FFS Bulk/Stik aboveground tank gauge equipment to an existing Moormann gaug