Franklin-fueling-systems TS-DIMIB Diagnostics Manuel d'utilisateur télécharger pdf

General Information

The T5 Series console* with an internal TS-DIMIB Dispenser

Interface Module has built in diagnostic software which

enables an installer to verify communication with the

dispenser / POS system.. This is a menu-based command

line utility which is available through the serial port of the

Power Supply Module. Control Module Firmware version

0.9.5.3685 or greater is required and Power Supply Firmware

version 1.0.1 or greater is required.

Prior to using diagnostic mode

Note:

If the console is not communicating with the

Distribution Box (Dbox), verify that the modules are

at the most current rev. level. If needed, upgrade the

system to current revs, turn off power to the T5 series

console, wait 5 minutes and turn power back on.

Note: If the mapping query is not working, set all hose

positions in set-up to 0 and save conguration.

Check status of the DIM module and wait until the

console shows the DIM is operational. Return to

setup and query dispenser.

In order to use this diagnostic, the console will need to

be placed into an ofine mode which essentially turns the

power supply into a dedicated module for DIM diagnostic

use only. During this time, the T5 console will not be

performing normal operational functions.

To return the console to its normal operation mode, it will

need to be power-cycled. This will allow the Power Supply

to return to its normal state. Note a Power Supply Module

Mismatch alarm will occur and should be ignored.

Procedure

Step 1

Using the LCD panel, select the main menu: FMS (Figure 1).

Figure 1: LCD Home Screen

This will take you to the Menu page. Press the DOWN

button (Figure 2).

Figure 2: Main Menu

This will show the diagnostics screen (Figure 3).

Figure 3: Diagnostics Button

TS-DIMIB Diagnostics

*T5 Consoles include TS-5, TS-550, TS-5000 and TS-EMS

1 2 3 4

Résumé du contenu

Page 1 - TS-DIMIB Diagnostics

1General InformationThe T5 Series console* with an internal TS-DIMIB Dispenser Interface Module has built in diagnostic software which enables an inst

Page 2

2Select the DIM Diagnostic in the Diagnostics section of the Main Menu (Figure 4). Figure 4: Diagnostics ScreenOnce selected you will be prompted to c

Page 3 - Figure 11: DIAG> Screen

3 Figure 10: Setting Baud RateOnce connected hit the Esc key to access the “DIAG>” prompt.Figure 11: DIAG> ScreenStep 3Accessing the Pump Totals

Commentaires sur ces manuels

Pas de commentaire

Franklin-fueling-systems TS-DIMIB Diagnostics Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Logiciel Franklin-fueling-systems TS-DIMIB Diagnostics. Franklin Fueling Systems TS-DIMIB Diagnostics User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Franklin-fueling-systems TS-DIMIB Diagnostics